MakerJuice Standard - Hard, Multi-Purpose Resin

$37.00
  • MakerJuice Standard - Hard, Multi-Purpose Resin
  • MakerJuice Standard - Hard, Multi-Purpose Resin
  • MakerJuice Standard - Hard, Multi-Purpose Resin
  • MakerJuice Standard - Hard, Multi-Purpose Resin

MakerJuice Standard - Hard, Multi-Purpose Resin

$37.00
$37.00

New Product Note: Our Standard resin has replaced G+, and should be used in places where G+ was used previously.

Standard is our go-to resin for all general purpose prints. Extremely fast curing enables it to work with printers such as the ANYCUBIC Photon, Wanhao D7, SparkMaker, etc. With lower viscosity than most resins on the market, it's easier to cleanup. This new, improved formula also has much more stable pigments, meaning no stirring during printing!

Standard cures under UV A, B, and C light up to 420nm. It can be cured with a DLP projector, a UV laser, or UV leds. When using UV lasers or LEDs, the cure time is extremely fast, so you don’t need much power.

This resin is low odor and contains zero VOC.

  • Standard has been tested and works on the following printers:

    • ANYCUBIC Photon
      • Layer Height: 100um
      • Layer Exposure: 15
      • Base Exposure: 40
      • Number Base Layers: 4
    • Wanhao D7
      • Layer Height: 100um
      • Layer Exposure: 15
      • Base Exposure: 40
      • Number Base Layers: 4
    • SparkMaker
      • LCD-E base resin
      • Layer Thickness: 0.1
      • Exposure Time: 15
      • Exposure Strength: 255
      • Bottom Layer Exposure Time: 40
      • Lift Distance: 5
      • Lift Speed: 20
      • Decline Speed: 80