Standard - Hard, Multi-Purpose Resin

$37.00
  • Standard - Hard, Multi-Purpose Resin
  • Standard - Hard, Multi-Purpose Resin
  • Standard - Hard, Multi-Purpose Resin
  • Standard - Hard, Multi-Purpose Resin
  • Standard - Hard, Multi-Purpose Resin
  • Standard - Hard, Multi-Purpose Resin

Standard - Hard, Multi-Purpose Resin

$37.00
$37.00

New Product Note: Our Standard resin has replaced G+, and should be used in places where G+ was used previously.

Standard is our go-to resin for all general purpose prints. Extremely fast curing enables it to work with printers such as the Elegoo Mars, ANYCUBIC Photon, Wanhao D7, etc. With lower viscosity than most resins on the market, it's easier to cleanup. This new, improved formula also has much more stable pigments, meaning no stirring during printing!

  • Standard has been tested and works on the following printers. Note that these settings are for the Grey color, and may need to be adjusted for other colors.

    • ELEGOO Mars
      • Layer Height: 0.1mm
      • Bottom Layer Count: 5
      • Exposure Time: 15s
      • Bottom Exposure Time: 40s
      • Light-off Delay: 0s
      • Bottom Light-off Delay: 0s
    • ANYCUBIC Photon
      • Layer Height: 100um
      • Layer Exposure: 15
      • Base Exposure: 40
      • Number Base Layers: 4
    • Wanhao D7
      • Layer Height: 100um
      • Layer Exposure: 15
      • Base Exposure: 40
      • Number Base Layers: 4
    • SparkMaker
      • LCD-E base resin
      • Layer Thickness: 0.1
      • Exposure Time: 15
      • Exposure Strength: 255
      • Bottom Layer Exposure Time: 40
      • Lift Distance: 5
      • Lift Speed: 20
      • Decline Speed: 80
  • Cures under UV A, B, and C light up to 420nm. Can be cured with a DLP projector, a UV laser, or UV LEDs. Low odor and contains zero VOC.

    Material Specifications:
    • Viscosity: 146 cP
    • Modulus: 149,147 PSI / 1028 MPa
    • Tensile: 7,542 PSI / 52 MPa
    • Elongation: 6%